Why is my candle tunneling? How to prevent an uneven burn
Published
A candle tunnels when the center burns down while a ring of wax stays around the jar. Short burns, especially the first one, can leave a narrow melt pool that repeats on later burns. On your next use, trim the cooled wick to 1/4 inch and allow enough supervised time for the wax to melt toward the edge, within the candle's four-hour limit. Never push wax into a burning candle or wrap the jar in foil.
What tunneling looks like
A tunnel is a deepening well around the wick, with a noticeable wall of unused wax along the glass. A thin film of wax on the side is different; it may be a normal part of how a jar candle burns. Watch the melt pool across a few uses before deciding that something is wrong.
Why the first burn matters
If a candle is put out before the melted wax spreads across the surface, later burns can follow that narrow ring. The National Candle Association calls it a memory ring. A draft or a wick that is too long can also make a flame burn unevenly.
For a jar candle, choose a time when you can stay in the room while the pool moves toward the edge. Follow the label's maximum burn time; for FULLNOTE candles, that is four hours. If the edge has not melted by then, put the candle out and let it cool. Do not extend the session to force an even surface.
A safe reset to try
Once the candle has fully cooled, trim the wick to about 1/4 inch and remove loose trimmings from the wax. Set the jar on a stable, heat-resistant surface away from fans, vents and open windows. Light it only when you can supervise a normal burn session, then let it cool before relighting.
Do not press the wax wall into the hot pool, dig around a lit wick, or use foil or another cover to trap heat around the flame. If the candle keeps burning in a deep, narrow well, stop using it and contact the seller for help.
When the candle is finished
Never burn a FULLNOTE candle below the 1/2-inch wax line in its jar. Some wax will remain at the bottom and may remain on the sides; that is safer than trying to burn every last bit. For the full routine, see our guide to the first burn and wick care.